Easy Crochet Water Bottle Holder

• pin now, crochet later!
• sharing is caring!

• pin now, crochet later!
• sharing is caring!

Here is the pattern :

Materials:

• 8-ply yarn
• 4.5mm crochet hook

Final Measurements: One sturdy, textured cup sleeve.

Pattern Notes:

• The cup sleeve is worked from the base upwards.
• Rnd = Round, worked in a spiral.
• Row = Row, worked back and forth.
• ch = chain
• dc = double crochet
• sc = single crochet
• sl st = slip stitch
• FPdc = front post double crochet
• BLO = back loop only
• Rep = repeat

Instructions:

Cup Base:

1. Make a magic ring.
2. Rnd 1: Ch 2 (does not count as a stitch here and throughout). Work 14 dc into the ring. Join with a sl st to the first dc. (14 dc)
3. Rnd 2: Ch 2. 2 dc in the first stitch (this is your first increase). 2 dc in each stitch around. Join with a sl st to the first dc. (28 dc)
   > Note: For a larger base, continue increasing each round by 14 stitches (i.e., Rnd 3 would have 42 dc, etc.) until the desired size is reached.

Cup Body:

4. Rnd 1 (BLO Rnd): Ch 2. Working into the BLO of each stitch, 1 dc in each stitch around. Join with a sl st to the first dc. (28 dc)
5. Rnd 2 (Pattern Start): Ch 2. [1 FPdc around the next dc, 1 dc in each of the next 3 dc]. Rep from [ ] 6 more times (7 times total). Join with a sl st to the first FPdc. (28 sts: 7 FPdc, 21 dc)
6. Rnd 3: Ch 2. [1 FPdc around the FPdc from the previous round, 1 dc in each of the next 3 dc (work these into the spaces/gaps of the previous round)]. Rep from [ ] 6 more times. Join with a sl st to the first FPdc. (28 sts)
7. Rnd 4+: Rep Rnd 3 continuously until the body reaches your desired height. Join the final round with a sl st.

Cup Rim:

8. Rnd 1: Ch 1 (does not count as a stitch). Working into both loops again, 1 sc in each stitch around. Join with a sl st to the first sc. (28 sc)
9. Rnd 2: Ch 1. 1 sc in each stitch around. Join with a sl st to the first sc. (28 sc)
10. Rnd 3 (Finishing Edge): Ch 1. Working into the BLO of each stitch, 1 sl st in each stitch around. Join with a sl st to the first sl st. Fasten off and weave in ends on the main body. (28 sl st)

Handle:

11. Row 1: With a new piece of yarn, join to the cup sleeve and ch 2. Work 3 dc into the same/next stitches (based on placement). (3 dc)
12. Row 2: Ch 2, turn. 1 dc in each dc across. (3 dc)
13. Rows 3+: Rep Row 2 until the handle reaches your desired length. Fasten off, leaving a long tail for sewing.

Finishing:

14. Position the handle on the opposite side of the cup sleeve. Using the long tail and a yarn needle, sew the final row of the handle firmly to 3 corresponding stitches on the cup sleeve. Weave in all ends.

Your textured mug cozy is complete!

• pin now, crochet later!
• sharing is caring!

• pin now, crochet later!
• sharing is caring!